Hotline: 0902862116
Manufacturers: HOCHIKI
Origin: Canada
DESCRIPTION:
- Large capacity of annunciation
- Bi-Colored LEDs
- Slide-in labels for each display point
- Sealed membrane-like buttons and LED indicators
- Each annunciation point is automatically selected for either Alarm (Red) or Supervisory (Amber) to match the HCP-1000 Fire Alarm Panel configuration
- LEDs for A.C. On, Common Trouble, Remote Failure, Aux. Disconnect, Ackowledge, General Alarm, Signal Silence and Test/Config Mode
- Controls for System Reset, Lamp Test, Fire Drill, Aux. Disconnect, Buzzer Silence, Signal Silence, General Alarm and Ackowledge
- Three sizes of enclosures
HRAM-1032- Main Annunciator Chassis
The HRAM-1032 Main Annunciator Chassis is an expandable module used in the HRA-1000 Series Remote Annunciators to provide control, indication of common annunciator functions and up to 32 points of annunciation. The HRAM-1032 comes standard with Bi-colored LEDs which are automatically configured for either alarm (Red) or Supervisory (Amber) to match the HCP-1000 Fire Alarm Control Panel configuration. Each display point can be identified by the slide-in label that slides in beside the LED. Equipped with sealed membrane-like buttons and LED indicators, the HRAM-1032 has a Local Buzzer as well as indicators for A.C. On, Common Trouble, Remote Failure, Aux. Disconnect, Acknowledge, General Alarm, Signal Silence and Test/Configuration mode. In addition it has controls for System Reset, Lamp Test, Fire Drill, Auxiliary Disconnect, Buzzer Silence, Signal Silence, General Alarm and Acknowledge. It occupies one slot in the HBB-1000 enclosures.
HRAX-1048 - Adder Annunciator Chassis
The HRAX-1048 Adder Annunciator Chassis is used in the HRA-1000 Series Remote Annunciators to provide 48 additional points of annunciation. The HRAX-1048 is an expandable annunciator module which can be connected to an HRAM-1032. A maximum of four HRAX-1048 can be connected to the HRAM-1032 Main Annunciator Chassis. As with the HRAM-1032 Main Annunciator Chassis, the HRAX-1048 has Bi-colored LEDs which are automatically configured for either Alarm (Red) or Supervisory (Amber) to match the HCP-1000 Fire Alarm Control Panel configuration. Each display point can be identified by the slide-in label that slides in besides the LED. It occupies one slot in the HBB-1000 enclosures.
